By using the site, you consent to the use of these cookies.
to learn more.
2005 Toyota 4Runner Ignition Chip Key Transponder Programming Instructions
To find a locksmith in your area.
How to Program a 2005 Toyota 4Runner Ignition Fob Smart Chip Key
Step by Step How to Programming Instructions:
Enter vehicle and close all doors, antitheft light will be blinking
Insert master key 5 into times into the ignition leaving master key in the ignition on the 5th insertion, antitheft light will be out.
Open and close driver’s door 6 times.
Remove master key from ignition, antitheft light stays on.
Verify that security light on the information display is solid, indicating that the car successfully entered programming mode
Insert new transponder chip key.
Watch security light blinking for about 60 seconds
When security light goes out, your new key should be successfully programmed
Remove newly programmed key from the ignition cylinder and insert master key and start engine. This will take vehicle out of programming mode.
Shut key off and insert the newly programmed key and start car.
If you need programming instructions for key fob
Check out our YouTube channel here
Copyright © 2024
All Rights Reserved.