How to Program a 2016 Ford Fusion Ignition Smart Chip Key
Step by Step How to Program Instructions:
Use these instructions if your Ford Fusion has the remote/flip key system.
You must have two previously programmed keys and the new unprogrammed key readily accessible. If you do not have two previously programmed keys you will need a Locksmith to cut and program a second key. If you have one working key you can Rent a Programmer here.
1. Insert the first previously programmed key into the ignition.
2. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds.
3. Switch the ignition off and remove the first programmed key from the ignition.
4. After three seconds but within 10 seconds of switching the ignition off, insert the second previously programmed key into the ignition.
5. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds.
6. Switch the ignition off and remove the second previously programmed key from the ignition.
7. After three seconds but within 10 seconds of switching the ignition off and removing the previously programmed key, insert the new unprogrammed key into the ignition.
8. Switch the ignition from off to on. Keep the ignition on for at least six seconds.
9. Remove the newly programmed key from the ignition. If the key has been successfully
programmed it will start the engine and operate the remote entry system (if the new key is an integrated keyhead transmitter). If it was not programmed successfully, wait 10 seconds and repeat Steps 1 through 8.
Use these instructions if your Ford Fusion has the smart key system.
Note: You can program a maximum for four smart keys to your vehicle. You must have two previously programmed keys and the new unprogrammed key readily accessible. If you do not have two previously programmed keys you will need a
Locksmith to cut and program a second key. If you have one working key you can
Rent a Programmer here.
Make sure that the vehicle is off before beginning this procedure. Make sure that you close all the doors before beginning and that they remain closed throughout the procedure. Perform all steps within 30 seconds of starting the sequence. Stop and wait for at least one minute before starting again if you perform any steps out of sequence.
Read and understand the entire procedure before you begin.
1. Place a programmed smart key in the backup slot in the center console. The key ring must be at the top with the buttons facing toward the rear.
2. Wait 5 seconds, then press the START/STOP button.
3. Remove the smart key.
4. Within 10 seconds, place a second programmed smart key in the backup slot and press the START/STOP button.
5. Wait 5 seconds, then press the START/STOP button again.
6. Remove the smart key.
7. Wait 5 seconds, then place the unprogrammed smart key in the backup slot and press the START/STOP button.
Programming is now complete. Verify the remote control functions operate and the vehicle starts with the new intelligent smart key.
If programming was not successful, wait 10 seconds and repeat Steps 1 through 7.