2024 Chevrolet TrailBlazer Ignition Fob Smart Chip Key Programming Instructions

Call 877-782-5192
To find a locksmith in your area.
Description
How to Program a 2024 Chevrolet Trailblazer Keyless Entry Remote Fob Smart Key
 
Step by Step How to Programming Instructions:
 
Programming with two Recognized Transmitters (Keyless Access) 
Each vehicle can have up to eight transmitters matched to it. 
 
A new transmitter can be programmed to the vehicle when there are two recognized transmitters. To program, the vehicle must be off and all of the transmitters, both currently recognized and new, must be with you.
 
1. Place the two recognized transmitters in the transmitter pocket of the center console storage area.
 
2. Insert the vehicle key of the new transmitter into the key lock cylinder on the outside of the driver door and turn the key to the unlock position five times within 10 seconds. The DIC displays READY FOR REMOTE #3, 4 or 5. 
 
3. Remove two recognized transmitters from transmitter pocket and place the new transmitter in the transmitter pocket.
 
4. Press ENGINE START/STOP. When the transmitter is learned, the DIC will show that it is ready to program the next transmitter.
 
5. Remove the transmitter from the transmitter pocket and press Unlock. To program additional transmitters, repeat Steps 3–5. When all additional transmitters are programmed, press and hold ENGINE START/STOP for 12 seconds to exit programming mode.
 
 
Programming without Recognized Transmitters (Keyless Access) 
If two currently recognized transmitters are not available, follow this procedure to program up to eight transmitters. This feature is not available in Canada. This procedure will take approximately 30 minutes to complete. The vehicle must be off and all of the transmitters to be programmed must be with you.
 
1. Insert the vehicle key of the transmitter into the key lock cylinder on the outside of the driver door and turn the key to the unlock position five times within 10 seconds. The DIC displays REMOTE LEARN PENDING, PLEASE WAIT.
 
2. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN and then press ENGINE START/STOP. The DIC displays will again show REMOTE LEARN PENDING, PLEASE WAIT.
 
3. Repeat Step 2 two additional times. After the third time, all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned during the next steps. The DIC display should now show READY FOR REMOTE # 1.
 
4. Place the new transmitter in the transmitter pocket located in center console between front seats.
 
5. Press ENGINE START/STOP. When the transmitter is learned, the DIC will show that it is ready to program the next transmitter.
 
6. Remove the transmitter from the transmitter pocket and press Unlock. To program additional transmitters, repeat Steps 4–6. 
 
When all additional transmitters are programmed, press and hold ENGINE START/STOP for 10 seconds to exit programming mode.  
Video